As mentioned in my previous post on the information I found on the new Rotor Power Meter, it became official yesterday that the Bicycle Power Profile is upgraded to V3.0. [ … ]
What is going to be in the new ANT+ Device Profile?
I’ve been diligently asking and looking and scouring the web for what metrics the new Rotor Power Meter will contain and now I know. Quote from the www.thisisant.com site: Balanced [ … ]
More Testing V3 Power Meter and ADS1247
Some longer testing (1.5 hours) today and I’ve come to a few conclusions. My calibration is off It doesn’t matter that my calibration is off, the crank shear gauge on [ … ]
Snow Storms, ADS1247, .NETMF, and Friday Night
Snow day today which means I didn’t make it into work. Seriously though, I tried. Shovelling out at 8am when the snow was at it’s worse and not a plow [ … ]
ADS1248 / ADS 1247 Received and Mounted
I got my breakout boards today for the 24 bit Sigma-Delta ADC’s. Soldered and conductivity tested. Now to wire them to an Arduino and a strain gauge. Approximately 3ma for [ … ]
ADS1247 / ADS1248
Well now that V3 is complete I’ve turned to debating what to do. I placed up my BT to ANT+ adapter, though few seem to have interest in that, or [ … ]
BT2.0 to ANT+ Video
I made a video that explains how to get the BT to ANT+ bridge working. Simple wiring as proposed with a how to and shows using my cell phone to [ … ]
Can I instrument a Carbon Crank?
I noticed a lot of traffic from www.slowtwitch.com which I found out is a huge forum on cycling. One of the largest I’ve ever seen. Someone mentioned my summary post [ … ]
BT 2.0 to ANT+ – So Cheap and Easy
Ignoring the other things on the board (AP2 Module and an AD623 which are not connected). After some initial configuration using an Arduino to set the baud rate to [ … ]
V3 Accuracy
Thanks to Hackaday viewers, Ray Maker at dcrainmaker.com, the various forums, twitter, reddit, and more. Again, feel free to ask questions or put in some comments. I’ll be sure to [ … ]